Chronique
Chronique Mod
Box mods

Vaporesso Armour Ultra mod only, what you buy without the iTank T

Written by Julien Marchand · · 9 min read approx.

Vaporesso Armour Ultra mod only, what you buy without the iTank T
Photograph: Rendy Novantino / Unsplash

Most listings for the Vaporesso Armour Ultra show the full kit, tank and coils included. Vaporesso also sells the device bare, with no tank and no coil, under almost the same name and with a near identical photo. Nothing forces a seller to spell out what is missing from the box. Buying the mod alone means making a choice the kit used to make for you, the atomiser. That choice is easier once you know what the maker actually publishes for this version, and what it leaves out.

Vaporesso Armour Ultra mod only or kit, the short answer

The Vaporesso Armour Ultra as a mod only suits someone who already owns a tank of 24 to 25 mm in diameter, or who wants to run a rebuildable atomiser. For a first purchase the kit avoids those questions, since it brings the iTank T, two GTi coils and the spare parts.

The bare mod carries exactly the same chipset, the same 5500 mAh battery and the same 100 W ceiling. What it hands back to the buyer is the question of diameter, on which the maker publishes no maximum figure.

Two official spec sheets, the kit and the Armour Ultra Mod

Vaporesso does more than offer the kit without its tank. The maker gives the bare device its own product page, under the name Armour Ultra Mod, with its own dimensions and its own box contents. Setting the two sheets side by side already says most of what matters.

CriterionArmour Ultra kitArmour Ultra Mod (mod only)
Stated dimensions144.5 x 37.6 x 31 mm90.7 x 31 x 37.6 mm
Stated weight256 g173 g
Battery and output5500 mAh, 100 W5500 mAh, 100 W
ChargingUSB-C, 9 V / 2 A or 5 V / 3 AUSB-C, 9 V / 2 A or 5 V / 3 A
TankiTank T, 6 ml or 2 ml TPD versionnone
CoilsGTi 0.2 and 0.4 ohm Dual Meshnone
CertificationsIP68, IP69K, MIL-STD-810HIP68, IP69K, MIL-STD-810H

Mod height, a figure that shifts from page to page

The official Armour Ultra Mod page gives a height of 90.7 mm for the bare device. A retailer listing for the same mod states 86.1 mm and 172 g. The gap is small, but it shows that a shop page sometimes copies another version or a rounded measurement. For a fitted case or a tight storage slot, the maker’s figure is the one to trust.

Global or TPD, one box for the bare mod

The maker lists two versions of the Armour Ultra Mod, Global and TPD, with strictly identical contents, namely the mod, a USB-C cable, the user manual and the warranty card. The TPD label therefore only concerns the tank in the kit. On the bare device it changes nothing about what arrives in the box.

What the mod only box leaves out

The official kit adds to the battery the iTank T, the pre-installed GTi Dual Mesh 0.2 ohm coil, a spare 0.4 ohm coil, a silicone refill plug, two O-rings, a glass tube and a spare tank protector. None of that comes with the Armour Ultra Mod.

The coils are the heaviest absence. GTi coils do not screw straight onto a mod, they need a tank built for the GTi platform, such as the iTank T. Buying the bare mod and adding the iTank T later simply rebuilds the kit one part at a time.

One more point is worth keeping in mind. The kit page states that all certifications and toughness tests apply to the mod only. Fitted with another tank, the Vaporesso Armour Ultra keeps its IP68 and IP69K ratings, but the assembled setup inherits no protection on the atomiser side.

Choosing a tank for the Vaporesso Armour Ultra mod

This is where the bare device asks for the most care. Three criteria decide which atomiser to fit, its diameter, its connection and the capacity allowed in the UK.

Diameter, which the maker does not publish

Neither of Vaporesso’s two pages gives a maximum diameter for a flush fit. Published pages put forward three different values, 24 mm in one English-language review, 25 mm in a French one and 26 mm on a retailer listing. The only official reference is the iTank T, which measures 24.5 mm across and 58.4 mm tall.

In practice, a tank of 24 to 25 mm lines up with what Vaporesso pairs with its own mod. Anything wider is worth checking against the top plate before you order, rather than relying on any one of those three values.

The 510 connection and the draw it is built for

The mod uses a 510 connector that the maker describes as reinforced, so any atomiser with a 510 thread will screw on. The kit is designed for direct lung vaping, and published pages present the whole setup as a direct lung device, with GTi coils rated between 30 and 90 W depending on their resistance.

A 2 ml tank in the UK

The iTank T comes in a 6 ml standard version, but UK rules cap refillable tanks at 2 ml, and nicotine e-liquid is sold in bottles of 10 ml at most, at no more than 20 mg/ml. The 2 ml TPD version is the one that matches the UK market, and the same limit applies to any other tank you pair with the mod.

Which Vaporesso Armour Ultra mode for the atomiser you fit

The AXON chip offers Boost, Pulse, Eco and temperature control. The right choice depends less on the mod than on the coil you fit, and this is where the bare version opens up options the kit never uses.

A ready-made coil

With a pre-built coil, the power modes are enough. Boost, Pulse and Eco change how the mod delivers its wattage, with no special setting required. The one rule is to stay within the wattage range printed on the coil, starting at the low end.

Nickel, titanium or stainless steel wire

Temperature control only works with a compatible wire. Two matching pages, a review and a retailer listing, say the Armour Ultra handles nickel, titanium and stainless steel. The maker does not give that list itself. It is the strongest argument for the bare mod among rebuild fans, provided you check the wire in your own build.

Mod only or kit, the verdict by profile

Both versions of the Vaporesso Armour Ultra share the same battery and the same protections. The buyer’s profile, and above all what they already own, makes the difference.

The vaper new to direct lung

The kit is the simpler version for this profile. It supplies a tank whose diameter matches the mod, two coils with documented wattage ranges and the spare seals. The only thing to check is that the version on sale carries the 2 ml tank.

The vaper who already has a tank

The bare mod makes sense if the atomiser measures 24 to 25 mm and uses a 510 thread. It avoids paying for an iTank T that would sit in a drawer. Our box mod buying guide covers the other points to check before this kind of purchase.

The rebuild enthusiast

This is the profile the Armour Ultra Mod suits best, thanks to temperature control stated for three wires. As with the Aspire Zelos 3, also sold as a mod only or as a kit, the decision starts with the atomiser you plan to fit.

FAQ

These five questions round off the buying guide above. They cover points that listings for the bare mod tend to leave in the dark.

Do GTi coils work on the mod only?

Not directly. A GTi coil sits inside a tank from the same platform, such as the iTank T, which then screws onto the mod. Without that tank, the bare mod uses no GTi coil at all.

What does the Armour Ultra Smart mode do?

Two published pages describe a Smart mode that suggests a wattage suited to the resistance of the coil it detects, and that can be switched off. The maker does not list it among the modes on its spec sheet, which sticks to Boost, Pulse, Eco and temperature control.

How long does a full charge take?

The pages disagree. A retailer listing claims under an hour, while an English-language review counts roughly two hours for a near-empty battery. The maker only states USB-C charging at 9 V / 2 A or 5 V / 3 A, so the real speed also depends on the charger you use.

How do I lock the mod in a bag?

A slider on the side locks the device, according to several matching reviews. If the mod stops responding after a trip in a pocket, that is the first setting to check before suspecting a fault.

What if the mod shows No Atomizer with a new tank?

The message means the mod cannot detect a coil, often because the 510 pin sits too low or the head is not screwed in properly. Our article on the No Atomizer message walks through the diagnosis step by step.

Vaporesso Armour Ultra mod only, a buy for those who know what to fit

Vaporesso documents its bare mod carefully on battery, weight and certifications, but leaves the atomiser diameter unanswered. The mod only version therefore makes sense with a tank already chosen and measured.

Before ordering a Vaporesso Armour Ultra without its iTank T, note the diameter of your atomiser and the capacity of its tank. The habit is worth keeping for any mod sold on its own, a format that gives the buyer more freedom, and more to check.

Editorial content for adult readers only. Vaping products can contain nicotine, which is a highly addictive substance. Vaping products are not for sale to anyone under 18 in the UK. This article is not a buying recommendation.